| Prior to installing a body kit on your car, you should | | | | bumper with the original factory bumper hardware.Side |
| take proper steps to ensure that it is done correctly. | | | | Skirt Installation:After removing your old side skirts, use |
| We encourage you to have the parts installed by a | | | | a cloth to clean the using the procedure mentioned |
| professional but for those you who want to do the | | | | above. Once prepped, pre-fit the side skirts onto the |
| project on their own these directions will get you | | | | car to make sure parts are properly aligned. Use a |
| started.Prepping & Cleaning Procedure:Using a good | | | | grease pencil to mark where you want to install the |
| quality paper towel and grease remover or lacquer | | | | side skirts. Now you will need to measure out a strip of |
| thinner, completely and thoroughly clean the painted | | | | double sided tape and attach it to the side underside of |
| surface area on the car where you will apply double | | | | the side skirt if they did not come with it. Peel back |
| sided tape. Do not allow the paper towel or cloth to | | | | about 2" of the plastic backing from the tape, so you |
| remain on the car for too long as it will cause damage | | | | can position the part on the car with the remaining |
| to the painted surface. Once cleaned, use a minimum | | | | plastic backing still on the tape. Position the part on the |
| amount of adhesion promoter (just enough to fully | | | | car and once in place pull the plastic backing to |
| coat the surface) on a clean lint-free cloth and apply a | | | | expose the double sided tape and press firmly to |
| thin coating to the surface where you will apply the | | | | assure good adhesion. If screw holes do not align |
| double face tape. All the adhesion promoter to | | | | properly you will need to drill them yourself at this point. |
| completely dry before you attempt installing the new | | | | Use a screwdriver to attach screws.Rear Bumper |
| part(s).Note: If you do not intend to paint your entire | | | | Installation:Remove your old factory rear bumper and |
| car, we highly recommend that you paint the bumper | | | | trim panel that is located above the bumper. Save all |
| prior to installing it on your car.Front Bumper | | | | of the original factory hardware for later use. You may |
| Installation:Remove your old factory bumper and save | | | | need to discard the styrofoam absorber as the new |
| all of the hardware to use later. You may need to | | | | bumper may not fit properly over it. Place the bumper |
| remove the styrofoam insert as the new bumper may | | | | on the car to test fit it. Once you have it lined up |
| not fit properly over it. Pre-fit the new bumper on the | | | | properly and fit is assured drill holes into the new |
| car to make sure that everything lines up. If it does not, | | | | bumper using the original factory bumper holes as a |
| make adjustments by sanding or grinding. Use your old | | | | reference. Using the original factory screws, attach the |
| factory bumper as a guide to drill new holes into your | | | | bumper to your car. You may need to drill additional |
| new bumper. Once you have done so install the new | | | | holes into each wheel well to secure the bumper. |